This guide will show you how to use DVD-Ranger to copy the Full DVD automatic from your DVDs onto a blank (single layer, 4.36GB) DVD-R, DVD+R, DVD-RW or DVD+RW disc.

Introduction & Requirements
DVD Ranger – Download and install this tool.
Decrypter – Download a decrypter like machinist2.dll, DVD43 or AnyDVD

Step1:
Insert DVD into your DVD drive

Step 2:
Select the desired project, by clicking on one of the target buttons. For this tutorial click on right hand part (Arrow) of the DVD-Player button and select from the pop up menu: “Automatic complete copy” (1).

Step 3:
From “Select your Source” (2), Select the location of source of your DVD; whether it is an ISO file, or present on hard disc, or on a removable storage device.

Step 4:
Wait for DVD-Ranger to analyze the disc completely. (The analyze window will close automatic).

Step 5:
Select the target (3). You have different target options. For this tutorial we select a DVD burning device.

Step 6:
Click on the button “Start Now!”

Step 7:
If you activated to remove the RegionCode (recommended) DVD-Ranger will ask you about the original RegionCode of the DVD if there are more than one possible.
Hint: You will find the original RegionCode at the back of the DVD cover.

Step 8:
DVD-Ranger now make a prescan(4) of the source DVD to calculate the best compression. After the prescan is done,DVD-Ranger will automatic switch to the copy mode(5). To stop the copy process press “Cancel” (6).

Step 9:
After the copy is finish, DVD-Ranger will check the selected burning device about a valid DVD blank. If now blank is found, DVD-Ranger will ask you to insert a new blank.

Step 10:
DVD-Ranger will now burn the DVD to the blank. You can stop the burn process by click the “Cancel” button.

Step 11:
After the burn process has successfully finished, you will see two new activated buttons. If you click on “Save Log” (7) you can save the current burn log file to disk, like to send it to our support.
After you have finished, you can burn a new copy by clicking on “New Copy”. You have also the possibility to save the current project to an ISO disk image file. If you have seen inside Step 9, that the wrong recording device was selected, you can change the recording device by clicking on “Change Device” (9) After this start a new process by clicking on “New Copy”.
To close this dialog, click on Done (8).