This guide will show you how to use DVD-Ranger to burn a ISO disk image from hard disc to a blank.

Introduction & Requirements
DVD Ranger – Download and install this tool.

Step1:
Start DVD-Ranger. Go to the menu “Burn” and click on “Burn Data CD/DVD” (1). By default, DVD-Ranger will open the burn dialog with the predefined disc type “Data CD/DVD” (2).

Step 2:
Select the target device where you want to burn the disk image file to (3).

Step 3:
Please select now the disk image file you want to burn. Click on “Select Image File” (4). A windows file selection dialog will open where you can select the ISO file.

Step 4:
If the file is in use, DVD-Ranger will inform you now. If you see dialog (5) please check whether the ISO image is mounted to a virtual drive.

If no disk is inside the recording device, like there is still the original, DVD-Ranger will give you this information now, after you inserted a blank, this message will close automaticly.
Remark: If you see, that the wrong recording device is selected, please click cancel and read further on Step 5.

Step 5:
The burn process will now start. After the burn process has successfully finished, you will see two new activated buttons. If you click on “Save Log” (5) you can save the current burn log file to disk, like to send it to our support.
After you have finished, you can burn a new copy by clicking on “New Copy”. You have also the possibility to save the current project to an ISO disk image file. If you have seen inside Step 9, that the wrong recording device was selected, you can change the recording device by clicking on “Change Device” (7) After this start a new process by clicking on “New Copy”.
To close this dialog, click on Done (6).